What it does
Changes the pattern of dashed lines or converts them to continuous lines.
How to proceed
To use continuous lines, click 
.
To create a dashed pattern, click 
and configure the following
fields:
and configure the following
fields:- In the On fields, enter the desired length of the dashes.
- In the Off fields, enter the desired size of the spaces between the dashes.
- In the Phase field, enter a value to indicate where the dash pattern should begin. For example, if you have chosen dashes of 5 cm each, if you have specified a phase of 2 cm, the first dash will have a length of 3 cm (5 cm - 2 cm).