Breakpoints indicate where the Action List Visualizer should pause processing. This is only relevant when you're visualizing the Action List in Run mode.
Note that breakpoints only are taken into account when they are visible. If they are hidden because they are part of a collapsed group, they are not taken into account.
Important: Processing will stop just before the Action with a breakpoint.
There are several ways to proceed:-
To add a breakpoint, click in the breakpoint column (to the right of the
Actions, below the icon
) next to the Action where you want a pause.
This will add a breakpoint icon 
.
-
To remove a breakpoint, click in the breakpoint column (to the right of the
Actions, below the icon ) on the breakpoint icon. The breakpoint is removed.
- To remove all breakpoints in one go, open the context menu and click Remove all breakpoints.
-
To add a breakpoint where there is none, or to remove one where there is one:
- Select an Action in the Action List.
- Open the context menu.
- Click Toggle breakpoint.