To go through an Action List, step by step, at your own speed, proceed as follows
- Make sure the Action List Visualizer is active. Starting the Action List Visualizer
-
To actually start visualizing, click the Step button
.
Only the Action with the pointer 
is executed. Immediately after the Action is
executed, the pointer moves to the next Action.
-
To proceed to the next Action, click the Step button
. Do this until you have reached the end of the
Action List.
Actions in a collapsed group are executed but not shown, meaning that the
pointer proceeds to the next visible Action in the Action List.
Breakpoints are ignored. They are only relevant in Run mode.
Once all Actions have been executed, you can see the end result of the Action List
in your sample document. You can now make changes if needed, and check the Action List
again from the beginning. To do so, click the Restart button 
to undo all
changes and move the pointer to the beginning of the Action List.
to undo all
changes and move the pointer to the beginning of the Action List.Note: You can also undo
the changes through the menu: .