If your Switch is running on Mac OS X, you can make sure that volumes will be remounted if the network connection is interrupted.
To configure remount volume information
- In Switch, navigate to .
-
Do one of the following:
- Select the Volume remount information field and
click
. - Double-click the Volume remount information field.
- Select the Volume remount information field and
click
-
Enter the following details:
- Volume path: The complete network path identifying a volume that may have to be remounted by Switch.
- User name: The user name to be used for
remounting the volume (required field).Note: Do not leave the user name empty! When closing the dialog, volumes without a user name are automatically removed if Show volume paths used by active flows is disabled (see step 4 of this procedure).
- Password: The password to be used for remounting the volume.
- Select or clear the Show volume paths used by active flows checkbox as
required:
- If selected (default value), all volume paths currently in used by active flows will be added to the list of volumes to be remounted. If the volume path contains a user name, it is added automatically as well, but this is NOT the case for the password. You must add the password manually.
- If cleared, all volume paths with an empty user name will be removed
from the list.
Note that the state of this checkbox (enabled/disabled) is remembered between uses of the property editor and across Switch sessions.
- Click OK.